full automatic hydraulic machine tapping type Installation method

Comments · 0 Views

full automatic hydraulic machine tapping type https://www.zjshuangzheng.com/How-can-we-choose-the-right-hydraulic-machine-manufacturer.html

Installation method of full automatic hydraulic machine tapping type:

Lifting and transportation

The lifting and position of the machine tool should be provided by the manufacturer with special lifting tools, and other methods are not allowed. No special lifting tools are required, the wire rope is lifted and seated according to specifications.

Foundation and location

The machine should be installed on a solid foundation and should be kept away from vibration sources. Avoid sunlight and heat radiation; Place in dry areas to avoid moisture and turbulence. If there is a vibration source near the machine tool, it is necessary to set up a seismic trench on the foundation.

Mounting machine

full automatic hydraulic machine tapping type Placed on the foundation, should be in a free state of flat, and then the ground bolt and anchor bolt evenly locked. For ordinary machine tools, the level reading of the level meter does not exceed 0.04/1000 mm, and for high-precision machine tools, the level of the horizon does not exceed 0.02/1000 mm. When measuring the installation accuracy, it should be carried out at a constant temperature, and the measuring tool should be used at a certain temperature. The machine tool should try to avoid forcing the machine deformation method. When the machine is installed, some parts of the machine should not be disassembled, and the removal of the parts may lead to the redistribution of the internal stress of the machine, thus affecting the accuracy of the machine.

Prepare before the test

After the geometry of the machine is qualified, the whole machine needs to be cleaned. A cotton cloth or silk soaked in detergent, not to be used on cotton or gauze. Anti-rust oil or anti-rust paint, used to protect rail surfaces and machining surfaces when the machine is disassembled. Clean the dust on the surface of the machine. Lubricating oil on the sliding surface and the surface of the working machine.

Carefully check that the parts of the machine have been oiled and the coolant is in the cooler. Whether the hydraulic station of the machine tool, the oil of the automatic lubrication device is in the position of the oil level indicator.

Check that switches and components are working properly in the electrical control box and that the integrated circuit board is in place. All lubes and lubes have lubes. Prepare all parts before machine parts.

full automatic hydraulic machine tapping type https://www.zjshuangzheng.com/How-can-we-choose-the-right-hydraulic-machine-manufacturer.html

Comments